MANAGED,
Table 7.2 Specific field information for the Modem Management screen.
FIELD | DESCRIPTION |
Date/Time | If the Date field is not changed, (e.g. stays 01/01/70) |
| the modem will keep track of the “uptime”. If the date |
| is set to the appropriate date, time is expressed by a |
| |
| over reboots. |
|
|
S/W Rev: | Current software version running on the modem |
|
|
H/W Rev.: | Current hardware version for the modem. |
|
|
MAC Address: | The Media Access Control (data link layer) address is |
| the physical address associated with the modem’s |
| LAN interface. |
|
|
Modem Name: | You can assign a name to this modem. Up to 14 |
| characters are allowed including underlines. Caution: |
| Do not use spaces or these characters: \ / : ? “< > . |
| After you assign a name, the modem name will appear |
| on every screen in the Modem field in the upper |
| |
|
|
Console Inactivity | You can enter a value for time out. The modem |
| automatically logs an operator off the network if |
| inactivity exceeds this |
| setting. The default is 10 minutes. Entering a zero (0) |
| disables this feature, which means the session will |
| keep running until an operator terminates it. |
|
|
Enable STP | Enable or disable Spanning Tree Protocol for bridging |
| purposes. The default is “Y” meaning “yes, it is |
| enabled.” If “N” or “No” is selected, both Master and |
| Slave should be disabled. |
|
|
Enable SNMP: | Enables or disables SNMP control. SNMP requires |
| that you assign an IP address to one of the modem |
| interfaces. |
| Note: When enabled, the modem will accept SNMP |
| requests. This field enables the entire feature set |
| (requests and notifications) for SNMP. The SNMP |
| management screen provides parameters for setting |
| up SNMP. The default is “Y” for enabled. |
|
|
LAN IP Address: | The LAN IP Address of the current modem. (It can also |
| be assigned in the Modem Configuration screen.) |
CAUTION: | Changing the values of either the IP Address, Subnet |
| mask, or Default gateway will automatically reboot the |
| modem. The screen displays a warning message. |
|
|
34 TUT SYSTEMS | 7.0 CONFIGURE THE MODEM |
