Symbologies 8-5
Introduction
This chapter describes all symbology features and provides the programming bar codes necessary for selecting these features for the scanner. Before programming, follow the instructions in Chapter 1, Getting Started.
The scanner is shipped with the settings shown in the Symbology Default Table on page 8- 6 (also see Chapter A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the default values suit the requirements, programming may not be necessary. Features values are set by scanning single bar codes or short bar code sequences.
To return all features to their default values, scan the Set All Defaults bar code on page
If the USB cable is not being used, a host type must be selected. See each host chapter for specific host information.
Scanning Sequence Examples
In most cases, only one bar code needs to be scanned to set a specific parameter value. For example, to transmit bar code data without the
bar code listed under Transmit
Other parameters, such as Set Length(s) for D 2 of 5 require that several bar codes be scanned in the proper sequence. See the individual parameter, like Set Length(s) for D 2 of 5, for this procedure.
Errors While Scanning
Unless otherwise specified, if an error is made during a scanning sequence, just
