Wasp Bar Code WLS 8400 ER, WLS 8400 FZ manual Beep After Good Decode, Trigger Mode, Level Trigger

4-8WLS 8400 Product Reference Guide

Beep After Good Decode

Scan a bar code below to select whether or not the scanner beeps after a good decode. If Do Not Beep After Good Decode is selected, the beeper still operates during parameter menu scanning and indicates error conditions.

*Beep After Good Decode

(Enable)

Do Not Beep After Good Decode

(Disable)

Trigger Mode

The scanner has three trigger modes that can be used to scan bar codes. The desired trigger mode can be set by using the bar codes below.

Level Trigger

When the trigger is pulled, an aiming dot appears for a programmable duration of time. After this time, the aiming dot automatically turns into a standard laser scanning beam for a full decode session. The laser scanning beam stays on until the laser-on timeout occurs, a decode occurs, or the trigger is released. If the trigger is released before the aiming duration expires, the laser shuts off and no decode occurs.

*Level