4.Close the clamp, push it back into place and tighten the screws on the clamp to secure the cable into the bottom of the scanner.
5.Connect the other end of the interface cable to the host (see the specific host chapter for information on host connections).
Different cables are required for different hosts. The connectors illustrated in each host chapter are examples only. The connectors may be different than those illustrated, but the steps to connect the scanner remain the same.
Connecting Power (if required)
If the host does not provide power to the scanner, an external power connection is required to power the scanner. To connect power:
1.Connect the interface cable to the bottom of the scanner, as described in Installing the Interface Cable on page
2.Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3.Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into an AC outlet.
