RD-9911 Warning Device Installation/Operation
To install the Warning Device, proceed as follows:
1.Connect the gold colored wire of the warning device wire harness to ignition +12 VDC (there is only +12 VDC present when ignition is turned ON) See Figure 17.
2.Connect the silver colored wire to vehicle ground. See Figure 17.
3.Connect other end of wire (end with molded plug) to warning device. See Figure 17.
4.Insert the two "AA" batteries into the warning device.
5.Connect the single RCA cable to the WARNING INDICATOR jack on positioner (see Figure 11). Connect the other end to the warning device. See Figure 17.
NOTE: It is recommended that you place the warning device where it will be visible when you start your vehicle. There is no buzzer, only lights in the device. Velcro is provided to help in the placement of the device.
Operation: A red light indicates that the system is still in the raised position and not ready for travel. Red light goes off when in down position. A yellow light comes on when battery is low. Lights only come on when +12 VDC is applied to warning device.
Positioner Rear Panel
WARNING
INDICATOR
RCA cable
Warning Device
Install two "AA" batteries provided
SILVER | Connect to vehicle ground |
| |
GOLD | Connect to ignition +12 VDC |
| |
| Figure 17 |
Rev. 6/98
15
