Azimuth Stop Condition | Azimuth Count - Numbers changed | ||||
according to antenna position | |||||
(see note) | |||||
|
|
| |||
|
|
|
| ||
| Az(X) = XXXXX |
|
| ||
| El (X) = XXXXX | XXX |
| ||
|
|
|
|
| |
Elevation Stop Condition
Signal Level - This will vary according to received signal
(see note)Azimuth Count - Numbers changed according to antenna position
Figure 28
NOTE: There are five (5) motor stop conditions: 0 - Motor stopped under normal conditions.
1 - Motor stopped because a limit switch was encountered.
2 - Motor stopped because motor count limit was reached.
3 - Motor stopped because s button was pressed on the positioner. 4 - Motor stopped because of elevation/rotation constraints (antenna was physically stopped by an obstruction or other obstacle).
Under normal conditions the stop conditions will be 0, 1, 2, or 3. If you get number 4, refer to Troubleshooting section.
36
