MANUAL MOVEMENT
2.Press SELECT A or B as appropriate
NOTE: All commands will be shown in bold with brackets, example [SELECT A].
Manual Movement: This function allows you to manually move the antenna. This feature is not normally used. Since the satellite signals are digital, once the system acquires the signal, you cannot improve the picture, only increase the signal strength. To manually move the antenna, proceed as follows:
NOTE: To manually lower the antenna to the travel position, refer to the Troubleshooting Manual.
1.Press [UP/DOWN] arrow until Manual Move is displayed on positioner. See Figure 26.
2.Press [SELECT A or B] Manual Move, see Figure 26.
1.Press UP/DOWN arrow buttons to get Manual Move on screen
SELECT A
SELECT B
PINNACLE POSITIONER
by WINEGARD
Manual Move Edit
Model
Figure 26 |
|
| |
3. | Press [ARROW BUTTONS] to move antenna in desired direction/position, | ||
see Figure 27. Figure 28 shows what the various numbers indicate on the | |||
positioner display. |
| ||
4. Press SELECT A to exit |
| 3. Press RIGHT | |
3. Press UP to raise antenna | to move antenna | ||
Manual Move | to the right | ||
| |||
SELECT A
SELECT B
PINNACLE POSITIONER
by WINEGARD
Az(3) = XXXXX |
|
El (3) = XXXXX | XXX |
Model
Figure 27 | 3. Press LEFT | 3. Press DOWN | |
to move antenna | |||
to lower antenna | |||
| |||
| to the left | ||
|
|
35
