SYSTEM OPERATION (FINDING THE SATELLITE(S)
Finding the Satellite
Method 1:
Using the City Menu
NOTE: SELECT A chooses top option, SELECT B chooses bottom option.
2. Press SELECT A
Your new Winegard RV Digital Satellite System is an
NOTE: All commands will be shown in bold with brackets, example [SELECT A].
One requirement must be met to fully enjoy automatic system TV viewing. The RV must be reasonably level. Any of the leveling indicators available should be adequate for this purpose. If the RV is not leveled, the system may not find the high power satellites.
After the RV has been leveled, proceed as follows:
There are three ways to find the satellite(s). Using the city menu to find the closest city, entering the elevation angle for your location or entering the latitude and longitude for your location. Each is explained in the following paragraphs.
1.Turn TV ON and tune to channel 3 or 4 (output channel of receiver).
2.Press [POWER] on receiver remote to turn satellite receiver on.
3.On positioner press [UP/DOWN] arrow button until Search DSS appears on the positioner screen, Figure 1. If you want to search for a different satellite refer to Edit Menu on page 18 to change search satellites.
1.Press UP/DOWN arrow buttons to get Search DSS on screen
SELECT A
SELECT B
PINNACLE POSITIONER
by WINEGARD
Search DSS Park
Model
Figure 1
3. Press SELECT A
4.Press [SELECT A] to enter the search function, Figure 1. (Press [SELECT B] if Search DSS is bottom option on screen.
5.Press [SELECT A] Select a City, Figure 2. There is a list of 125 cities in the continental Untied States stored in the positioner memory. See Programmed City Locations, page 28.
SELECT A
SELECT B
PINNACLE POSITIONER
by WINEGARD
Select a City Enter Elevation
Model
24 Figure 2 | Rev. 6/97 |
