Winegard RD-9946 installation manual Do not Caulk Mount Base Ring

Seal connections from point to point indicated

Figure 7	Use FS-8100 connector to
	connect coax cables

5.Set mount assy. onto the mount base, making sure to coil cables under mount base. Make cables do not make contact with the azmuth limit switches on the bottom of the mount assembly, Figure 9. Rotate mount assembly. counterclockwise to lock mount onto mount base. Secure mount assy. to mount base using screws provided. See Figure 8.

Mount Assembly

(2)10-32 x 5/8" Hex Head Screw

(2)10-32 Washer

Point to front of vehicle

DO NOT CAULK

MOUNT BASE

RING

Mount Base

Antenna Support

Figure 8

Set mount assy. onto the mount base and rotate so that it locks into place. Secure mount assy. to mount base with screws provided.

Caulk all mounting holes and cable entry.

Coil cables under mount base. Make sure cables do not make contact with the limit switches on the bottom of the mount assenbly.

Antenna Support mounting hole(s) 1/4" dia.

Rev 9/98

7