NOTICES
WARNING: Use of unsuitable materials may result in poor performance and can possibly create a hazardous condition.
Always use a Xerox specified cordset with the Equipment Leakage
Circuit Interrupter/Residual Current Device (ELCI/RCD).
Use caution when installing or modifying telephone lines.
Do not do this
Never use an extension cord with the ELCI/RCD.
Never use the ELCI/RCD where water may enter the casing.
Never attempt any maintenance function that is not specifically described in this document.
Never remove any covers or guards that are fastened with screws unless otherwise instructed. There are no
Never override or ªcheatº electrical or mechanical devices.
Never operate the equipment if you notice unusual noises or odors. Disconnect the power cord from the power source receptacle and call your service representative to correct the problem.
Never install telephone wiring during a lightening storm.
Never install telephone jacks in a wet location unless specifically designated for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightening.
Never use a telephone to report a gas leak in the vicinity of the leak.
U.S. only: If you need any additional safety information concerning the equipment or Xerox supplied materials, call the following
Approvals and certification
60 Hz, 115 V Listed by Underwriters Laboratories, UL1950 (UL). Meets CSA standards, C22.2 NO 950 (CSA).
50 Hz, 220 to 240 V Meets the British Standards Institution, IEC950 (BSI).
Safety feature
Your printer is equipped with an Equipment Leakage Circuit Interrupter/Residual Current Device (ELCI/RCD). This safety device protects you if an electric outlet supplying power to the printer is improperly wired.
XEROX 4220 LPS FAX MODEM FOR MACINTOSH OPERATOR GUIDE | v |
