Yamaha 02R Digital Cascade Kit (CD8-CS)

Installing Options 183
Digital Recording Console 02R User’s Guide
Digital Cascade Kit (CD8-CS)
The digital cascade kit (CD8-CS) is used to connect two or more Digital
Recording Console 02R units together. The kit consists of two cascade I/O
cards and a special cable. When two or more 02R units are connected
together, they share the output buses 1 through 8, four auxiliary buses (two
paired buses, AUX A and AUX B), the stereo bus, and the solo bus.
Installing the CD8-CS
The cascade I/O card (CD8-CS) is a single slot card. At least one cascade
I/O card should be installed in each 02R. If you are connecting more than
two units, the middle units should have two cards. The cascade I/O cards
should be installed in SLOT3 or SLOT4. You should reserve SLOT1 and
SLOT2 for digital I/O cards.
For installation instructions, see “Single Slot Cards” on page 175 of the
User’s Guide.
1. Set the IN/OUT switch of the cascade I/O card installed in the first
02R to the IN position.
This unit will be the cascade master.
2. Set the IN/OUT switch of the cascade I/O card installed in the
second 02R to the OUT position.
This unit will be the cascade slave.
02R cascade slave (Word clock slave)
75 switch ON 02R cascade slave (Word clock slave) 75 switch ON
SLOT 1 SLOT 2
Digital MTR
(Word clock master) Digital MTR
(Word clock slave)
Digital MTR
(Word clock slave)
Digital MTR
(Word click
slave)
SLOT 2 SLOT 1
SYNC
SYNC
SYNC
SLOT 4 SLOT 4
WORD CLOCK OUT
WORD
CLOCK
IN
WORD
CLOCK
IN
WORD
CLOCK
OUT
OUT IN
CD8-CS