Instruments and indicators
1
2
km/h | 1 |
(km) | 2 |
| |
mph | 3 |
| |
(mile) | 4 |
knots | 3 |
(mile) | |
|
ZMU07001
1.Cap
2.Selector switch (for speed unit)
3.Selector switch (for fuel sensor)
EMU26713
Fuel gaugeEight segments indicate the fuel level. When all segments are showing, the fuel tank is full.
To change the display, press the “
” (mode) button repeatedly until the indicator on
the face of the gauge points to “
” (trip
meter), “
” (clock), or “
” (voltmeter).
EMU26691
Trip meter
This gauge displays the distance the boat has traveled since the gauge was last reset.
The trip distance is shown in kilometers or miles depending upon the unit of measurement selected for the speedometer.
To reset the trip meter to zero, press the “
”
(set) and “
” (mode) buttons at the same time.
The trip distance is kept in memory by battery power. The stored data will be lost if the battery is disconnected.
ZMU07002
The fuel level reading can be inaccurate due to the position of the sensor in the fuel tank and the attitude of the boat in the water. Operation with
Do not adjust the selector switch for fuel sen- sor. Incorrectly setting the selector switch on the gauge will give false readings. Consult your Yamaha dealer on how to correctly set the selector switch. NOTICE: Running out of
fuel can damage the engine. [ECM01770]
EMU36071
Trip meter / Clock / VoltmeterThe display shows either the trip meter, the clock, or the voltmeter.
YAMAHA
SPEED
km/h knot mph
km mile
TRIP TIME BATT
set mode
ZMU07003
EMU40841
Clock
To set the clock
1.Push the “
” (mode) button to change
the display to the “
” (clock) mode.
2.Push the “
” (set) button. The hour dis- play will begin blinking.
3.Push the “
” (mode) button until the desired hour value is displayed.
4.Push the “
” (set) button again. The 10- minute display will begin blinking.
5.Push the “
” (mode) button until the desired
6.Push the “
” (set) button again. The 1- minute display will begin blinking.
33