Trouble Recovery
A. Have serviced by a Yamaha dealer.
EMU29433
Temporary action in emergency
EMU29441
Impact damage
EWM00870
WARNING
The outboard motor can be seriously damaged by a collision while operating or trailering. Damage could make the outboard motor unsafe to operate.
If the outboard motor hits an object in the wa- ter, follow the procedure below.
ZMU06999
1.Stop the engine immediately.
2.Check the control system and all compo- nents for damage. Also, check the boat for damage.
3.Whether damage is found or not, return to the nearest harbor slowly and careful- ly.
4.Have a Yamaha dealer check the out-
board motor before operating it again.
EMU40952
Replacing fuse
EWM00631
WARNING
Substituting an incorrect fuse or a piece of wire could allow excessive current flow. This could cause electric system damage and a fire hazard.
If a fuse has blown, replace the fuse according to the following procedure.
1.Turn the main switch to the “
” (off) po- sition.
2.Remove the fuse box cover.
3.When replacing the main fuse, remove the screws, and then remove the main fuse. Install the spare main fuse, and then tighten the screws.
1
9
2 3 4 5 6 7 8
ZMU06960
1.Fuse box cover
2.Main fuse (60 A)
3.Fuel feed pump fuse (10 A)
4.Main switch / PTT switch fuse (20 A)
5.Starter relay fuse (30 A)
6.Ignition coil / Fuel injector / Variable cam- shaft timing / ECM (Electronic Control Mod- ule) fuse (30 A)
7.Electric throttle valve fuse (10 A)
8.Fuel pump fuse (15 A)
9.Screw
3 | 1 | 2 |
2
ZMU06961
1.Spare main fuse (60 A)
2.Spare fuse (10 A, 15 A, 20 A, 30 A)
3.Fuse puller
85