Operation
3.To return the outboard motor to the nor-
N | mal running position, push the “ ” |
| |
| (down) side of the power trim and tilt |
| switch to tilt the outboard motor down |
| slowly. |
ZMU07034
DN
N
1
ZMU06926
2.Push the “
” (up) side of the power trim and tilt switch to tilt the outboard motor up slightly to the desired position.
WARNING! Using the power trim and tilt switch on the bottom cowling while the boat is moving or engine is on could increase the risk of falling over- board and could distract the operator, increasing the risk of collision with an- other boat or an obstacle. [EWM01850]
1
UP
ZMU06987
1. Power trim and tilt switch
EMU41370
Operating in other conditions
Operating in salt water
After operating in saltwater, brackish water, or water high in other minerals, flush the cooling system with fresh water to minimize corrosion and clogging of the cooling water passages with deposits. Also, rinse the exterior of the outboard motor with fresh water.
Operating in water containing mud, sand, silt, debris, or vegetation
Mud, sand, silt, debris, and vegetation in the water may restrict water flow into the cooling water inlet covers or clog internal water pas- sages. Check and clean the cooling water inlet covers frequently when operating in these conditions. Flush the engine with clean, fresh water after use in these environments. Consult your dealer if normal water flow can not be restored by cleaning the cooling water inlet covers or flushing with fresh water.
ZMU06986
1. Power trim and tilt switch
64