Trouble Recovery

4.When replacing a fuse other than the

main fuse, remove the fuse using the fuse puller. Install a spare fuse of the proper amperage.

Consult your Yamaha dealer if the new fuse immediately blows again.

EMU40981

Power trim and tilt unit will not operate

If the outboard motor cannot be tilted up or down using the power trim and tilt unit because of a discharged battery or a failure with the power trim and tilt unit, the outboard motor can be tilted manually.

1.Stop the engine.

2.Loosen the manual valve screw by turn- ing it counterclockwise until it stops.

1

ZMU06962

1.Manual valve screw

3.Tilt the outboard motor up manually to the desired position, and then tighten the manual valve screw by turning it clock-

wise.

EMU41013

Water separator-alert indicator blinks while cruising

EWM02542

WARNING

Gasoline is highly flammable, and its vapors are flammable and explosive.

●Do not perform this procedure on a hot or running engine. Allow the engine to cool.

●There will be fuel in the fuel filter. Keep away from sparks, cigarettes, flames or other sources of ignition.

●Some fuel will spill during this proce- dure. Catch the fuel in a rag. Wipe up any spilled fuel immediately.

●The fuel filter must be reassembled carefully with the O-ring and filter cup in place. Improper assembly or replace- ment could result in a fuel leak, which could result in a fire or explosion hazard.

If the water separator-alert indicator on the Command Link tachometer blinks, perform the following procedure.

1

1

ZMU06963

1.Water separator-alert indicator

1.Stop the engine.

2.Remove the top cowling.

3.Remove the bolts, and then remove the fuel filter cover.

1

2

1

ZMU06964

1.Bolt

2.Fuel filter cover

86