Yamaha Yamaha Mixing Consol, M2500 Stereo/monaural master section, Stereo section, MONO/C section

Control panel

Stereo/monaural master section

This section controls the signals that are output from the rear panel ST OUT L/R and MONO/C OUT jacks (page 28).

15

MATRIXMATRIX

	CHECK	CHECK
2	ON	ON	6
	ON/EDIT	ON/EDIT
	10	10
	5	5
	0	0
	5	5
	10	10
	20	20
	30	30
	40	40
3	50	50	8
	60	60
4	AFL	AFL	7

STEREO MONO/C

STEREO section

A MATRIX switch

If this switch is on (), the post-fader ST OUT L/R signal will be sent to the matrix (page 18).

B ON/EDIT switch / ON, CHECK indicators

The function of this switch and these indicators will change depending on the mode of the M2500.

●In normal mode

You can use the ON/EDIT switch to turn ST OUT L/ R on/off. When this is switched on/off, the ON indi- cator will be lit/dark to indicate the status. Channels that are switched off will not send any signals to the ST OUT L/R jacks or to the matrix.

●In check mode

When a scene (which contains the on/off state of the ON/EDIT switches) is selected, the on/off status memorized in that scene will be indicated by the lit/ dark status of the CHECK indicator. In check mode, you can also use the ON/EDIT switch to switch the CHECK indicator between lit/dark. (The current on/ off setting will not be affected.) For details on check mode, refer to page 32.

CFader

This adjusts the ST OUT L/R output level.

DAFL switch

Using this switch, the signal sent to the ST OUT L/R jacks can be monitored from the MONITOR OUT/ PHONES jacks. If the PFL switches of all input chan- nels are off, turning this AFL switch on (the indicator above the switch will light) will allow you to monitor the output signal of the STEREO section from the MONITOR OUT/PHONES jacks. Use the MASTER PFL switch of the monitor section to switch the mon- itor signal between pre/post-fader.

MONO/C section

E MATRIX switch

If this switch is on (), the post-fader MONO/C sig- nal will be sent to the matrix (page 18).

F ON/EDIT switch / ON, CHECK indicators

The function of this switch and these indicators will change depending on the mode of the M2500.

●In normal mode

You can use the ON/EDIT switch to turn MONO/C OUT on/off. When this is switched on/off, the ON indicator will be lit/dark to indicate the status. Chan- nels that are switched off will not send any signals to the MONO/C jack or to the matrix.

●In check mode

When a scene (which contains the on/off state of the ON/EDIT switches) is selected, the on/off status memorized in that scene will be indicated by the lit/ dark status of the CHECK indicator. In check mode, you can also use the ON/EDIT switch to switch the CHECK indicator between lit/dark. (The current on/ off setting will not be affected.) For details on check mode, refer to page 32.

GFader

This adjusts the output level of MONO/C.

16 M2500—Owner’s Manual