Zebra Technologies GX430D, GX420D manual Attaching Power

14

Getting Started

Attaching Power

Attaching Power

Important • Set up your printer so that you can handle the power cord easily if needed. To make certain the printer cannot carry electrical current, you must separate the power cord from the power supply receptacle or AC electrical outlet.

Caution • Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!

1.Make sure the printer’s power switch is in the off position (down).

2.Insert the AC power cord into the power supply.

3.Plug the other end of the cord into an appropriate AC electrical outlet. Note: The active power light will go on if power is on at the AC outlet.

4.Insert the power supply’s power connector into the printer’s power receptacle.

Printer

Plug Varies

by Country

Power

Switch

	Power
	Connector
	Power
Power	Supply

Receptacle

AC

Power

Cord

Active Power Light

IEC 60320

C-13

Note • Ensure the appropriate power cord with a three (3) prong plug and an IEC 60320-C13 connector are used at all times. These power cords must bear the relevant certification mark of the country in which the product is being used.

980611-001 Rev. C GX420d™ / GX430d™ User Guide 8/4/10