Table 41 Classifier (continued)
LABEL DESCRIPTION
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN | Select Any to classify traffic from any VLAN or select the second option and specify the |
| source VLAN ID in the field provided. |
|
|
Priority | Select Any to classify traffic from any priority level or select the second option and specify |
| a priority level in the field provided. |
Ethernet | Select an Ethernet type or select Other and enter the Ethernet type number in |
Type | hexadecimal value. Refer to Table 43 on page 150 for information. |
Source |
|
|
|
MAC | Select Any to apply the rule to all MAC addresses. |
Address | To specify a source, select the second choice and type a MAC address in valid MAC |
| address format (six hexadecimal character pairs). |
Port | Type the port number to which the rule should be applied. You may choose one port only |
| or all ports (Any). |
Destination |
|
|
|
MAC | Select Any to apply the rule to all MAC addresses. |
Address | To specify a destination, select the second choice and type a MAC address in valid MAC |
| address format (six hexadecimal character pairs). |
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP | Select Any to classify traffic from any DSCP or select the second option and specify a | |
| DSCP (DiffServ Code Point) number between 0 and 63 in the field provided. | |
|
| |
IP | Select an IP protocol type or select Other and enter the protocol number in decimal value. | |
Protocol | Refer to Table 44 on page 151 for more information. | |
| You may select Establish Only for TCP protocol type. This means that the switch will pick | |
| out the packets that are sent to establish TCP connections. | |
Source |
| |
|
| |
IP | Enter a source IP address in dotted decimal notation. | |
Address/ | Specify the address prefix by entering the number of ones in the subnet mask. | |
Address | ||
| ||
Prefix |
| |
|
| |
Socket | Note: You must select either UDP or TCP in the IP Protocol field before | |
Number | you configure the socket numbers. |
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and enter a TCP/UDP protocol port number.
Destination
IP | Enter a destination IP address in dotted decimal notation. | |
Address/ | Specify the address prefix by entering the number of ones in the subnet mask. | |
Address | ||
| ||
Prefix |
|
Socket | Note: You must select either UDP or TCP in the IP Protocol field before |
Number | you configure the socket numbers. |
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second |
| option and enter a TCP/UDP protocol port number. |
Chapter 18 Classifier | 149 |