ES-3124 User’s Guide

The following table describes the related labels you use to create a static route.

Table 59 Static Routing

LABEL

DESCRIPTION

 

 

DSCP Setting

Click DSCP Map to open the screen where you can set up the mapping between

 

source DSCP priority and IEEE 802.1p priority.

Active

This field allows you to activate/deactivate DiffServ on the switch.

 

 

Port

This read-only index number indicates which port you are activating.

 

 

*

Settings in this row apply to all ports.

 

Use this row only if you want to make some settings the same for all ports. Use this

 

row first to set the common settings and then make adjustments on a port-by-port

 

basis.

 

Note: Changes in this row are copied to all the ports as soon as you

 

make them.

Active

This allows you to activate DiffServ on a per port basis.

 

 

Apply

Click Apply to save your changes to the switch’s run-time memory. The switch loses

 

these changes if it is turned off or loses power, so use the Save link on the top

 

navigation panel to save your changes to the non-volatile memory when you are done

 

configuring.

Cancel

Click Cancel to reset the fields.

25.3 Configure DSCP Setting

Use this screen to convert DSCP priority to IEEE 802.1p priority. Click IP Application, DiffServ, DSCP in the navigation panel to display the screen as shown.

Chapter 25 DiffServ Code Point

189