|
|
| |
| Table 27 | MRSTP: Configuration (continued) | |
|
|
|
|
| LABEL |
| DESCRIPTION |
|
|
|
|
| Apply |
| Click Apply to save your changes to the switch’s |
|
|
| loses these changes if it is turned off or loses power, so use the Save link on the |
|
|
| top navigation panel to save your changes to the |
|
|
| are done configuring. |
| Cancel |
| Click Cancel to reset the fields. |
|
|
|
|
11.6 Multiple Rapid Spanning Tree Protocol Status
Click Advanced Application, Spanning Tree Protocol in the navigation panel to display the status screen as shown next. See Section 11.1 on page 107 for more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the switch.
Figure 50 MRSTP: Status
The following table describes the labels in this screen.
Table 28 Spanning Tree Protocol: Status
LABEL | DESCRIPTION |
|
|
Configuration | Click Configuration to configure MRSTP settings. Refer to Section 11.3 on page |
| 110. |
Tree | Select which STP tree configuration you want to view. |
|
|
Bridge | Root refers to the base of the spanning tree (the root bridge). Our Bridge is this |
| switch. This switch may also be the root bridge. |
Bridge ID | This is the unique identifier for this bridge, consisting of bridge priority plus MAC |
| address. This ID is the same for Root and Our Bridge if the switch is the root |
| switch. |
Hello Time | This is the time interval (in seconds) at which the root switch transmits a |
(second) | configuration message. The root bridge determines Hello Time, Max Age and |
| Forwarding Delay |
Chapter 11 Spanning Tree Protocol | 117 |