ZyXEL Communications omni.net LCD+M manual 161

Technical Reference for ZyXEL omni.net series

All the Following Commands Require a 'AT' Prefix

	S Com.		bit		dec			hex		Function and description	+Def./Ref.
S29=				0-39		0-39			Set default dial phone number pointer, use 'AT&Zn=s' to		+000 *D
									store phone numbers.
S31=				0-25			0-FF			Holds the ASCII decimal value of the XON.	+017
				5
S32=				0-25			0-FF			Holds the ASCII decimal value of the XOFF.	+019
				5
S35=			bit		dec			hex		Bit mapped register
		6		64		30			Enable password protection to profile saving, when		&Wn
									<AT&Wn> is issued, and the 'n' profile in the memory has
									this bit on, supervisory password will be requested.
		7		128		60			Enable extended numerical result codes from 50-71 when		V0
									an error corrected connection is made. Use with 'ATV0' (see		S23b6
									result code table).
S36=			bit		dec			hex		Bit mapped register	+000
		5-7								Security function control register
				0 (*)		0				Disable security function.	*G0
				32		20			Enable type 1 security, with password check (Proprietary).		*G1
				64		40				Enable type 1 security, with password check and callback	*G2
									(Proprietary).
				96		60			Enable type 2 security, with password check.		*G3
				128		80				Enable type 2 security, with password check and callback.	*G4
				160				A0		Enable type 2 security, with password check and callback.	*G5
									Remote site enters the callback number.
S38=			bit		dec			hex		Bit mapped register	+000
		0		1		1			Repeatedly dialing default number.		*Dn, S29
		1-2								Reserved.
		2		4		4			Key for ATSWR, ATHWR.
		3		8		8			DCD on/off sequence follows UNIX standard, DCD high		&C1 S21b4
									before connect message is sent, DCD off after last DCE
									response is sent.
S40=			bit		dec			hex		Bit mapped register	+000
		1		2		2			No result code displayed in answer mode.		Q2

B-9