Chapter 8 LAN Setup
Table 27 Advanced LAN Setup (continued)
LABEL | DESCRIPTION |
Allow between | Select this check box to forward NetBIOS packets from the LAN to the WAN and |
LAN and WAN | from the WAN to the LAN. If your firewall is enabled with the default policy set to |
| block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall |
| rule that forwards NetBIOS traffic. |
| Clear this check box to block all NetBIOS packets going from the LAN to the WAN |
| and from the WAN to the LAN. |
|
|
Back | Click Back to return to the previous screen. |
|
|
Apply | Click Apply to save the changes. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
8.5 DHCP Setup
Click Network > DHCP Setup to open this screen. Use this screen to configure the DNS server information that the ZyXEL Device sends to the DHCP client devices on the LAN.
Figure 57 DHCP Setup
The following table describes the labels in this screen.
Table 28 | DHCP Setup | |
LABEL |
| DESCRIPTION |
DHCP Setup |
| |
|
|
|
DHCP |
| If set to Server, your ZyXEL Device can assign IP addresses, an IP default |
|
| gateway and DNS servers to Windows 95, Windows NT and other systems that |
|
| support the DHCP client. |
|
| If set to None, the DHCP server will be disabled. |
|
| If set to Relay, the ZyXEL Device acts as a surrogate DHCP server and relays |
|
| DHCP requests and responses between the remote server and the clients. |
|
| Enter the IP address of the actual, remote DHCP server in the Remote DHCP |
|
| Server field in this case. |
|
| When DHCP is used, the following items need to be set: |
|
|
|
112 |
| |
| ||
|
|
|