Chapter 3 Internet and Wireless Setup Wizard

Figure 17 Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

Table 5 Internet Access Wizard Setup: ISP Parameters

LABEL

DESCRIPTION

Mode

From the Mode drop-down list box, select Routing (default) if your ISP allows

 

multiple computers to share an Internet account. Otherwise select Bridge.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list

 

box. Choices vary depending on what you select in the Mode field.

 

If you select Bridge in the Mode field, select either PPPoA or RFC 1483.

 

If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or

 

PPPoE.

Multiplexing

Select the multiplexing method used by your ISP from the Multiplex drop-down list

 

box either VC-based or LLC-based.

 

 

Virtual Circuit

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.

ID

Refer to the appendix for more information.

 

 

VPI

Enter the VPI assigned to you. This field may already be configured.

 

 

VCI

Enter the VCI assigned to you. This field may already be configured.

 

 

Back

Click Back to go back to the previous screen.

 

 

Next

Click Next to continue to the next wizard screen. The next wizard screen you see

 

depends on what protocol you chose above.

 

 

Exit

Click Exit to close the wizard screen without saving your changes.

 

 

2The next wizard screen varies depending on what mode and encapsulation type you use. All screens shown are with routing mode. Configure the fields and click Next to continue. See Section 3.3 on page 65 for wireless connection wizard setup

 

61

P-2602H(W)(L)-DxA User’s Guide