Chapter 9 Wireless LAN
Table 38 Wireless LAN: Advanced
LABEL | DESCRIPTION |
Fragmentation | It is the maximum data fragment size that can be sent. Enter a value between 256 |
Threshold | and 2432. If you select the G+ Enhanced checkbox a value of 4096 is displayed. |
|
|
Preamble | Select a preamble type from the |
| Dynamic. The default setting is Long. See the appendix for more information. |
802.11 Mode | Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to |
| associate with the ZyXEL Device. |
| Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to |
| associate with the ZyXEL Device. |
| Select Mixed to allow either IEEE 802.11b or IEEE 802.11g compliant WLAN devices |
| to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device |
| might be reduced. |
|
|
Enable | Select Enable 802.11g+ mode checkbox to allow any ZyXEL WLAN devices that |
802.11g+ | support this feature to associate with the ZyXEL Device at higher transmission |
mode | speeds. This permits the ZyXEL Device to transmit at a higher speed than the |
| 802.11g Only mode. |
|
|
Back | Click this to return to the previous screen without saving changes. |
|
|
Apply | Click Apply to save your changes back to the ZyXEL Device. |
|
|
Cancel | Click Cancel to reload the previous configuration for this screen. |
|
|
9.6 OTIST Screen
Use this screen to set up and start OTIST on the ZyXEL Device in your wireless network.To open this screen, click Network > Wireless LAN > OTIST.
"Ensure that your network’s SSID is fewer than 23 characters in length before you start OTIST. Click WIRELESS > General to change your network’s SSID.
Figure 68 Network > Wireless LAN > OTIST
128 |
| |
| ||
|
|
|