ZyXEL Communications P-2602H 10.5.1 Port Forwarding Rule Edit

Chapter 10 Network Address Translation (NAT) Screens

Table 46	Port Forwarding
LABEL		DESCRIPTION
Server IP		This is the server’s IP address.
Address

Modify		Click the edit icon to go to the screen where you can edit the port forwarding rule.
		Click the delete icon to delete an existing port forwarding rule. Note that
		subsequent address mapping rules move up by one when you take this action.

Apply		Click Apply to save your changes back to the ZyXEL Device.

Cancel		Click Cancel to return to the previous configuration.

10.5.1 Port Forwarding Rule Edit

Use this screen to edit a port forwarding rule. Click the rule’s edit icon in the Port Forwarding screen to display the screen shown next.

Figure 82 Port Forwarding Rule Setup

The following table describes the fields in this screen.

Table 47 Port Forwarding Rule Setup

LABEL	DESCRIPTION
Active	Click this check box to enable the rule.

Service Name	Enter a name to identify this port-forwarding rule.

Start Port	Enter a port number in this field.
	To forward only one port, enter the port number again in the End Port field.
	To forward a series of ports, enter the start port number here and the end port
	number in the End Port field.

End Port	Enter a port number in this field.
	To forward only one port, enter the port number again in the Start Port field above
	and then enter it again in this field.
	To forward a series of ports, enter the last port number in a series that begins with
	the port number in the Start Port field above.

Server IP	Enter the inside IP address of the server here.
Address

Back	Click Back to return to the previous screen.

Apply	Click Apply to save your changes back to the ZyXEL Device.

Cancel	Click Cancel to begin configuring this screen afresh.