Figure 146 Remote Management: SNMP
The following table describes the labels in this screen.
Table 109 Remote Management: SNMP
LABEL | DESCRIPTION |
|
|
SNMP |
|
|
|
Port | You may change the server port number for a service if needed, however you |
| must use the same port number in order to use that service for remote |
| management. |
Access Status | Select the interface(s) through which a computer may access the ZyXEL Device |
| using this service. |
Secured Client IP | A secured client is a “trusted” computer that is allowed to communicate with the |
| ZyXEL Device using this service. |
| Select All to allow any computer to access the ZyXEL Device using this service. |
| Choose Selected to just allow the computer with the IP address that you specify |
| to access the ZyXEL Device using this service. |
SNMP Configuration |
|
|
|
Get Community | Enter the Get Community, which is the password for the incoming Get and |
| GetNext requests from the management station. The default is public and allows |
| all requests. |
Set Community | Enter the Set community, which is the password for incoming Set requests from |
| the management station. The default is public and allows all requests. |
Trap |
|
|
|
Community | Type the trap community, which is the password sent with each trap to the |
| SNMP manager. The default is public and allows all requests. |
Destination | Type the IP address of the station to send your SNMP traps to. |
|
|
Apply | Click Apply to save your customized settings and exit this screen. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
258 | Chapter 17 Remote Management Configuration |