ZyXEL Communications P-661HW manual 332

P-661H/HW Series User’s Guide

Table 142 Firewall Commands (continued)

FUNCTION	COMMAND	DESCRIPTION
	Config edit firewall set <set	This command sets whether or not the ZyXEL
	#> log <yes no>	Device creates logs for packets that match the
		firewall’s default rule set.
Rules	Config edit firewall set <set	This command sets whether packets that
	#> rule <rule #> permit	match this rule are dropped or allowed
	<forward block>	through.
	Config edit firewall set <set	This command sets whether a rule is enabled
	#> rule <rule #> active <yes	or not.
	no>
	Config edit firewall set <set	This command sets the protocol specification
	#> rule <rule #> protocol	number made in this rule for ICMP.
	<integer protocol value >
	Config edit firewall set <set	This command sets the ZyXEL Device to log
	#> rule <rule #> log <none	traffic that matches the rule, doesn't match,
	match not-match both>	both or neither.
	Config edit firewall set <set	This command sets whether or not the ZyXEL
	#> rule <rule #> alert <yes	Device sends an alert e-mail when a DOS
	no>	attack or a violation of a particular rule occurs.
	config edit firewall set <set	This command sets the rule to have the
	#> rule <rule #> srcaddr-	ZyXEL Device check for traffic with this
	single <ip address>	individual source address.
	config edit firewall set <set	This command sets a rule to have the ZyXEL
	#> rule <rule #> srcaddr-	Device check for traffic from a particular
	subnet <ip address> <subnet	subnet (defined by IP address and subnet
	mask>	mask).
	config edit firewall set <set	This command sets a rule to have the ZyXEL
	#> rule <rule #> srcaddr-range	Device check for traffic from this range of
	<start ip address> <end ip	addresses.
	address>
	config edit firewall set <set	This command sets the rule to have the
	#> rule <rule #> destaddr-	ZyXEL Device check for traffic with this
	single <ip address>	individual destination address.

332 Appendix G