The following table describes the fields in this screen.
Table 12 Internet Setup Wizard: ISP Parameters (Ethernet)
LABEL | DESCRIPTION |
|
|
Obtain an IP | Select this if you have a dynamic IP address. |
Address |
|
Automatically |
|
Static IP | Select this if you have a static (fixed) IP address, and enter the information below. |
Address |
|
| These fields appear if you select Static IP Address. |
|
|
IP Address | Enter the static IP address provided by your ISP. |
|
|
Subnet Mask | Enter the subnet mask provided by your ISP. |
|
|
Gateway IP | Enter the IP address of the gateway provided by your ISP. If your ISP did not provide |
Address | one, use the default value. |
First DNS | Enter the IP address(es) of the DNS server(s) provided by your ISP. If your ISP did not |
Server | provide one or both, use the default value(s). |
Second DNS |
|
Server |
|
Back | Click Back to go back to the previous screen. |
|
|
Apply | Click Apply to finish manual configuration. The ZyXEL Device tries to detect the |
| connection again. See Section 3.1 on page 60. |
Exit | Click Exit to close the wizard screen without saving your changes. |
|
|
This screen appears if your Internet connection uses PPPoE encapsulation.
Figure 23 Internet Setup Wizard: ISP Parameters (PPPoE)
Chapter 3 Wizards | 63 |