ZyXEL Communications 4528F, 4728F, XGS-4526 8.7 Port Setup

Chapter 8 Basic Setting

Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the navigation panel to display the configuration screen.

Figure 36 Basic Setting > Port Setup

The following table describes the labels in this screen.

Table 14 Basic Setting > Port Setup

LABEL	DESCRIPTION
Port	This is the port index number.

*	Settings in this row apply to all ports.
	Use this row only if you want to make some settings the same for all ports.
	Use this row first to set the common settings and then make adjustments
	on a port-by-port basis.

	Note: Changes in this row are copied to all the ports as soon as you
	make them.

Active	Select this check box to enable a port. The factory default for all ports is
	enabled. A port must be enabled for data transmission to occur.

Name	Type a descriptive name that identifies this port. You can enter up to 64
	alpha-numerical characters.

	Note: Due to space limitations, the port name may be truncated in
	some web configurator screens.

Type	This field displays 10/100/1000M for a 1000Base-T connection, 10G for
	a 10 Gigabit Ethernet connection, and 12G for a 10GBase-CX4 connection
	in the XGS-4528F or XGS-4728F.