Chapter 29 Layer 2 Protocol Tunneling

29.2 Configuring Layer 2 Protocol Tunneling

Click Advanced Application > Layer 2 Protocol Tunneling in the navigation panel to display the screen as shown.

Figure 139 Advanced Application > Layer 2 Protocol Tunneling

The following table describes the labels in this screen.

Table 92 Advanced Application > Layer 2 Protocol Tunneling

LABEL

DESCRIPTION

Active

Select this to enable layer-2 protocol tunneling on the Switch.

 

 

Destination

Specify an MAC address with which the Switch uses to encapsulate the

MAC Address

layer-2 protocol packets by replacing the destination MAC address in the

 

packets.

 

Note: The MAC address can be either a unicast MAC address or

 

multicast MAC address. If you use a unicast MAC address,

 

make sure the MAC address does not exist in the address

 

table of a switch on the service provider’s network.

 

Note: All the edge switches in the service provider’s network should

 

be set to use the same MAC address for encapsulation.

 

 

Port

This field displays the port number.

 

 

 

293

XGS-4526/4528F/4728F User’s Guide