Chapter 7 System Status and Port Statistics
The following table describes the labels in this screen.
Table 8 Status
LABEL | DESCRIPTION |
Port | This identifies the Ethernet port. Click a port number to display the Port |
| Details screen (refer to Figure 31 on page 97). |
|
|
Name | This is the name you assigned to this port in the Basic Setting > Port |
| Setup screen. |
|
|
Link | This field displays the speed (either 10M for 10 Mbps, 100M for 100 |
| Mbps, 1000M for 1000 Mbps, and 10G for 10 Gbps) and the duplex (F |
| for full duplex or H for half). It also shows the cable type (Copper or |
| Fiber) for the combo ports. This field displays Down if the port is not |
| connected to any device. |
|
|
State | If STP (Spanning Tree Protocol) is enabled, this field displays the STP |
| state of the port. (See Section 13.1.3 on page 149 for more information). |
| If STP is disabled, this field displays FORWARDING if the link is up, |
| otherwise, it displays STOP. |
|
|
LACP | This fields displays whether LACP (Link Aggregation Control Protocol) has |
| been enabled on the port. |
|
|
TxPkts | This field shows the number of transmitted frames on this port. |
|
|
RxPkts | This field shows the number of received frames on this port. |
|
|
Errors | This field shows the number of received errors on this port. |
|
|
Tx KB/s | This field shows the transmission speed of data sent on this port in |
| kilobytes per second. |
|
|
Rx KB/s | This field shows the transmission speed of data received on this port in |
| kilobytes per second. |
|
|
Up Time | This field shows the total amount of time in hours, minutes and seconds |
| the port has been up. |
|
|
Clear Counter | Type a port number, select Port and then click Clear Counter to erase |
| the recorded statistical information for that port, or select Any to clear |
| statistics for all ports. |
|
|
96 |
| |
| ||
|
|
|