Chapter 25 AAA

Table 72 Supported VSAs

FUNCTION

ATTRIBUTE

 

 

Egress Bandwidth

Vendor-Id = 890

Assignment

Vendor-Type = 2

 

Vendor-data = egress rate (Kbps in decimal format)

Privilege

Vendor-ID = 890

Assignment

Vendor-Type = 3

 

Vendor-Data = "shell:priv-lvl=N"

 

or

 

Vendor-ID = 9 (CISCO)

 

Vendor-Type = 1 (CISCO-AVPAIR)

 

Vendor-Data = "shell:priv-lvl=N"

 

where N is a privilege level (from 0 to 14).

 

Note: If you set the privilege level of a login account differently

 

on the RADIUS server(s) and the Switch, the user is

 

assigned a privilege level from the database (RADIUS or

 

local) the Switch uses first for user authentication.

 

 

25.2.5 Tunnel Protocol Attribute

You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS server documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x authentication. The port VLAN settings are fixed and untagged. This will also set the port’s VID. The following table describes the values you need to configure. Note that these attributes only work when you enable authorization (see Section 25.2.3 on page 249).

Table 73 Supported Tunnel Protocol Attribute

FUNCTION ATTRIBUTE

VLAN Assignment Tunnel-Type = VLAN(13)

Tunnel-Medium-Type = 802(6)

Tunnel-Private-Group-ID = VLAN ID

Note: You must also create a VLAN with the specified VID on the Switch.

Note: The bolded values in this table are fixed values as defined in RFC 3580.

 

253

XGS-4526/4528F/4728F User’s Guide