Chapter 20 Classifier
Table 49 | Advanced Application > Classifier (continued) | |
LABEL | DESCRIPTION | |
Socket | Note: You must select either UDP or TCP in the IP Protocol field before | |
Number | ||
you configure the socket numbers. | ||
| ||
| Select Any to apply the rule to all TCP/UDP protocol port numbers or select | |
| the second option and enter a TCP/UDP protocol port number. | |
|
| |
Add | Click Add to insert the entry in the summary table below and save your | |
| changes to the Switch’s | |
| is turned off or loses power, so use the Save link on the top navigation panel | |
| to save your changes to the | |
| configuring. | |
|
| |
Cancel | Click Cancel to begin configuring this screen afresh. | |
|
| |
Clear | Click Clear to set the above fields back to the factory defaults. | |
|
|
20.3Viewing and Editing Classifier Configuration
To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over a lower layer rule.
Figure 88 Advanced Application > Classifier: Summary Table
The following table describes the labels in this screen.
Table 50 Classifier: Summary Table
LABEL | DESCRIPTION |
Index | This field displays the index number of the rule. Click an index number to edit |
| the rule. |
|
|
Active | This field displays Yes when the rule is activated and No when it is |
| deactivated. |
|
|
Name | This field displays the descriptive name for this rule. This is for identification |
| purposes only. |
|
|
Rule | This field displays a summary of the classifier rule’s settings. |
|
|
204 |
| |
| ||
|
|
|