Chapter 24 Multicast
Table 64 Advanced Application > Multicast > Multicast Setting > IGMP Snooping VLAN (continued)
LABEL | DESCRIPTION |
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
VLAN | Use this section of the screen to add VLANs upon which the Switch is to |
| perform IGMP snooping. |
|
|
Name | Enter the descriptive name of the VLAN for identification purposes. |
|
|
VID | Enter the ID of a static VLAN; the valid range is between 1 and 4094. |
| Note: You cannot configure the same VLAN ID as in the MVR |
| screen. |
|
|
Add | Click Add to insert the entry in the summary table below and save your |
| changes to the Switch’s |
| changes if it is turned off or loses power, so use the Save link on the |
| top navigation panel to save your changes to the |
| when you are done configuring. |
|
|
Cancel | Click Cancel to reset the fields to your previous configuration. |
|
|
Clear | Click this to clear the fields. |
|
|
Index | This is the number of the IGMP snooping VLAN entry in the table. |
|
|
Name | This field displays the descriptive name for this VLAN group. |
|
|
VID | This field displays the ID number of the VLAN group. |
|
|
Delete | Check the rule(s) that you want to remove in the Delete column, then |
| click the Delete button. |
|
|
Cancel | Click Cancel to clear the Delete check boxes. |
24.5 IGMP Filtering Profile
An IGMP filtering profile specifies a range of multicast groups that clients connected to the Switch are able to join. A profile contains a range of multicast IP addresses which you want clients to be able to join. Profiles are assigned to ports (in the Multicast Setting screen). Clients connected to those ports are then able to join the multicast groups specified in the profile. Each port can be assigned a single profile. A profile can be assigned to multiple ports.
| 233 |
|
|