Chapter 35 Policy Routing
The following table describes the labels in this screen.
Table 110 IP Application > Policy Routing > Rule Configuration
LABEL | DESCRIPTION |
Profile Name | This field displays the policy routing profile(s) you configure in the IP |
| Application > Policy Routing screen. |
| Select a profile for which you want to configure a policy routing rule. |
|
|
Sequence | Enter the rule number from 1 to 64. The ordering of your rules is |
| important as rules are applied in turn. |
| You can not specify a number already in use by another rule. |
|
|
Statement | Select Permit to forward traffic that matches this rule to the gateway |
| specified in the rule. |
| Select Deny to disable the rule action and forward traffic that matches |
| this rule according to the routing table on the Switch. |
|
|
Classifier | This field displays the available active classifiers you configure in the |
| Classifier screen (see Chapter 20 on page 201), which are not used by |
| any policy rule or policy routing rule. |
| Select a classifier to which this policy routing rule applies. |
|
|
Action | Enter the IP address of the gateway. The gateway is an immediate |
| neighbor of your Switch that will forward the packet to the destination. |
|
|
Add | Click Add to insert the entry in the summary table below and save your |
| changes to the Switch’s |
| if it is turned off or loses power, so use the Save link on the top navigation |
| panel to save your changes to the |
| done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
Clear | Click Clear to set the above fields back to the factory defaults. |
|
|
Active | This field displays whether the policy route profile is enabled or not. |
|
|
Profile Name | This field displays the name of the policy route profile with which the rule |
| is associated. |
|
|
Seq | This field displays the rule index number that you configure in the |
| Sequence field. Click an index number to change the rule’s Statement. |
|
|
State | This field displays permit when the rule action is activated and deny |
| when is it deactivated. |
|
|
Classifier | This field displays the name of the classifier to which this policy applies. |
|
|
Rule Delete | Select the policy routing rule(s) that you want to remove. |
|
|
Delete | Click Delete to remove the selected entry(ies) from the summary table. |
|
|
Cancel | Click Cancel to clear the Rule Delete check boxes. |
|
|
326 |
| |
| ||
|
|
|