Chapter 5 WAN Setup
5.4.1 Layer 2 Interface Configuration
Click the Add button in the Layer 2 Interface screen to open the following screen. Use this screen to create a new
Figure 29 Layer 2 Interface Configuration: DSL PTM WAN
The following table describes the fields in this screen.
Table 13 Layer 2 Interface Configuration
LABEL | DESCRIPTION |
Select | Select Default Mode to allow only one WAN service over a single |
Connection Mode | virtual circuit. |
| Select MSC Mode to allow multiple WAN services over a single virtual |
| circuit. Each WAN connection has its own MAC address. |
| Select VLAN MUX Mode to allow multiplexing of multiple protocols |
| over a single virtual circuit. You need to assign a VLAN ID and priority |
| level to traffic through each WAN connection. All WAN connections |
| share one MAC address. |
|
|
Enable Quality Of | Select this option to activate QoS (Quality of Service) on this interface |
Service | to group and prioritize traffic. Traffic is grouped according to the VLAN |
| group. |
| The QoS setting applies to all WAN connections over the same PVC. |
|
|
Back | Click this button to return to the previous screen without saving any |
| changes. |
|
|
Apply/Save | Click this button to save your changes and go back to the previous |
| screen. |
|
|
72 |
| |
| ||
|
|
|