Cub Cadet CC2000 manual Troubleshooting, U S E T I O N

Section 7

Troubleshooting

ENGINE WILL NOT START

C A U S E

On/Off Stop Control is in STOP position Empty fuel tank

Primer bulb wasn't pressed enough Engine flooded

Old or improperly mixed fuel

Fouled spark plug

Plugged spark arrestor

ENGINE WILL NOT IDLE

C A U S E

Air Filter is Plugged

Old or improperly mixed fuel

Improper carburetor adjustment

A C T I O N

Turn On/Off Stop Control to START Fill fuel tank with properly mixed fuel Press primer bulb fully and slowly 5-7 times

Use starting procedure with choke lever in the RUN position, Pg. 10

Drain gas tank / Add fresh fuel mixture Replace or clean the spark plug Clean or replace spark arrestor

A C T I O N

Replace or clean the air filter

Drain gas tank / Add fresh fuel mixture Adjust per instruction Pg. 16

ENGINE WILL NOT ACCELERATE

C A U S E

Old or improperly mixed fuel Improper carburetor adjustment

Cutting attachment bound with grass Dirty air filter

Plugged spark arrestor

A C T I O N

Drain gas tank / Add fresh fuel mixture

Take to an authorized service dealer for carburetor adjustment

Stop the engine and clean the cutting attachment Clean or replace the air filter

Clean or replace spark arrestor

ENGINE LACKS POWER OR STALLS WHEN CUTTING

C A U S E	A C T I O N
Old or improperly mixed fuel	Drain gas tank / Add fresh fuel mixture
Improper carburetor adjustment	Take to an authorized service dealer for
	carburetor adjustment
Fouled spark plug	Replace or clean the spark plug
Plugged spark arrestor	Clean or replace spark arrestor

CUTTING ATTACHMENT WILL NOT ADVANCE LINE

C A U S E	A C T I O N
Cutting attachment bound with grass	Stop the engine and clean cutting attachment
Cutting attachment out of line	Refill with new line
Inner reel bound up	Replace the inner reel
Cutting head dirty	Clean inner reel and outer spool
Line welded	Disassemble, remove the welded section
	and rewind the line
Line twisted when refilled	Disassemble and rewind the line
Not enough line is exposed	Push the Bump Knob and pull out line until
	4 inches (102 mm) of line is outside of the
	cutting attachment

18