Cub Cadet CC2000 manual Oil and Fuel, Unleaded GAS

Page 9

Section 4

+

UNLEADED GAS

Cub Cadet 2 CYCLE OIL

1 US. GALLON

+ 4.0 FL. OZ.

(3.8 LITERS)

(118 ml)

MIXING RATIO - 32:1

Fig. 4-1

Oil and Gas Mixing Instructions

Old and/or improperly mixed fuel are the main reasons for the unit not running properly. Be sure to use fresh, clean unleaded fuel. Follow the instructions carefully for the proper fuel/oil mixture.

Definition of Blended Fuels

Today's fuels are often a blend of gasoline and oxygenates such as ethanol, methanol or MTBE (ether). Alcohol-blended fuel absorbs water. As little as 1% water in the fuel can make fuel and oil separate. It forms acids when stored. When using alcohol-blended fuel, use fresh fuel (less than 60 days old).

Using Blended Fuels

If you choose to use a blended fuel, or its use is unavoidable, follow recommended precautions.

Always use fresh fuel mix per your operator's manual.

Always agitate the fuel mix before fueling the unit.

Drain the tank and run the engine dry before storing the unit.

Using Fuel Additives

The bottle of Cub Cadet 2-Cycle oil that came with your unit contains a fuel additive which will help inhibit corrosion and minimize the formation of gum deposits.It is recommended that you use only

Cub Cadet 2-Cycle oil with this unit.

Oil and Fuel

If unavailable, use a good 2-cycle oil designed for air-cooled engines along with a fuel additive, such as STA-BIL® Gas Stabilizer or an equivalent. Add 0.8 oz. (23 ml) of fuel additive per gallon of fuel according to the instructions on the container. NEVER add fuel additives directly to the unit's fuel tank.

For proper engine operation and maximum reliability, pay strict attention to the oil and fuel mixing instructions on the 2-cycle oil container. Using improperly mixed fuel can severely damage the engine.

Thoroughly mix the proper ratio of 2-cycle engine oil with unleaded gasoline in a separate fuel can. Use a 32:1 fuel/oil ratio. Do not mix them directly in the engine fuel tank. See Figure 4-1 for specific gas and oil mixing ratios.

NOTE: One gallon (3.8 liters) of unleaded gasoline mixed with one 4 oz. (118 ml) bottle of Cub Cadet 2-CYCLE OIL makes a 32:1 fuel/oil ratio.

Gasoline is extremely flammable. Ignited Vapors may explode. Always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.

Remove fuel cap slowly to avoid injury from fuel spray. Never operate the unit without the fuel cap securely in place.

Add fuel in a clean, well ventilated area outdoors. Wipe up any spilled fuel immediately. Avoid creating a source of ignition for spilt fuel. Do not start the engine until fuel vapors dissipate.

NOTE: Dispose of the old fuel/oil mix in accordance to Federal, State, and Local regulations.

9

Image 9
Contents Operator’s Manual Table of Contents Symbol Meaning SafetySafety Warnings for GAS Trimmers SectionOther Safety Warnings SafetyWhile Operating OperationSymbol Meaning Safety Alert Symbol Safety and International SymbolsFor Service INFORMATION, Call Unleaded FuelDo not USE Blades Trimmer Safety Symbol Meaning Sharp Blade Choke ControlApplications Know Your UnitAssembly Installing and Adjusting the D-HANDLEInstalling the Cutting Attachment Shield Unleaded GAS Oil and FuelOperation Starting InstructionsStopping Instructions Operation Adjusting Trimming Line LengthHolding the Trimmer Tips for Best Trimming ResultsMaintenance Schedule MaintenanceWhen Maintenance Needed GO to Line InstallationGo To for Membrane Line Installation MaintenanceWinding the Existing Inner Reel LoopInstalling a Prewound Reel Replacement Parts See Accessories / Replacement Parts onHolding Slots AIR Filter Maintenance Spark Arrestor MaintenanceCleaning the Air Filter Clean Air Filter Carburetor AdjustmentCheck Fuel Mixture Idle Speed ScrewCleaning ACCESSORIES/REPLACEMENT PartsReplacing the Spark Plug StorageU S E TroubleshootingT I O N U S E T I O NEngine SpecificationsCub Cadet LLC MANUFACTURER’S Limited Warranty forManuel de lutilisateur Copiez le numéro Numéro de sérieDe modèle / pièce ici Copiez le numéro deSécurité Symbole SignificationLire Toutes LES Instructions Avant UtilisationPendant Lutilisation DE Lappareil Sécurité suiteAutres Avertissements DE Sécurité FonctionnementCommande MARCHE/ARRÊT Stop Symbole Alerte DE SécuritéAvertissement Lisez LE Manuel DE Lutilisateur Pour LES Questions DentretienLevier Détrangleur Lame AiguiséeNutilisez PAS DE Lames DÉSHERBEUSE/DÉBROUISSAILLEUSE SécuritéFamiliarisez-vous avec l’appareil Installation DU Protecteur Daccessoire DE Coupe Installation ET Réglage DE LA Poignée EN DCorps de larbre Collier deEssence Sans Huile 2-TEMPS Plomb Mélange Dhuile ET DE CarburantFonctionnement Instructions DE DémarrageInstructions Darrêt Tenue DE LA Désherbeuse Fonctionnement suiteRéglage DE LA Longueur DU FIL Conseils Pour Bien DésherberQuand Entretien Requis Voir EntretienCoupe Décorative Programme DentretienEntretien suite Boucle Fentes de Retenue Pièces de rechangeEntretien DU PARE-ÉTINCELLES Entretien DU Filtre À AIRVérification du mélange de carburant Réglage DU CarburateurNettoyage du filtre à air Vis de réglageAccessoires / Pièces DE Rechange L U T I O N DépannageU S ES O L U T I O N U S E L U T I O N41 mm 0.095 po 41.55 cm 17 poDiamètre du chemin de coupe Garantie Limitée DU Fabricant Pour Manual del Dueño/Operador Número del modelo Indice DE MateriasSeguridad SecciónSimbolo DE Alerta DE Seguridad Durante LA Operacion Seguridad continuaciónOtras Advertencias DE Seguridad OperaciónAdvertencia LEA EL Manual DEL Operador Simbolo Significado Simbolo DE Alerta DE SeguridadPara Obtener Informacion Acerca DEL Servicio Llame USE Proteccion Ocular Y AuditivaControl DEL Obturador Simbolo Significado Cuchilla AfiladaNo USE Cuchillas Seguridad DE LA Recortadora Y Cortadora DE MalezasAplicaciones Conozca su unidadArmado Instalación Y Ajuste DE LA Manija EN DInstalación DEL Protector Accesorio DE Corte Gasolina SIN Galon DE EE.UU. + 4.0 Onzas FluidasPlomo Ciclos Instrucciones Para Mezclar EL Aceite Y EL CombustibleOperación Instrucciones DE ArranqueInstrucciones DE Apagado Como Sostener EL Recortador Operación continuaciónAjuste DE LA Longitud DE LA Linea DE Corte Consejos Para Obtener Mejores Resultados AL RecortarCuando Mantenimiento Necesario Pase a LA MantenimientoRecorte Decorativo Programa DE MantenimientoBobina Eje Bobinado del carrete interior existenteLazo Instalación DE UN Carrete Prebobinado Mantenimiento continuaciónPiezas de repuesto Ranuras deMantenimiento DEL Filtro DE Aire Mantenimiento DEL ParachispasLimpieza del filtro de aire Ajuste DEL Carburador Controle la mezcla del combustibleLimpie el filtro de aire ACCESORIOS/REPUESTOS U S a Solución de desperfectosC I O N U S a C I O NEspecificaciones Garantía Limitada DEL Fabricante Para