Homelite UT80432 Washing with Detergent, Rinsing with the Pressure Washer, See Figures 18

Page 16

OPERATION

WASHING WITH DETERGENT

See Figures 18 - 19.

Use only detergents designed for pressure washers; house- hold detergents, acids, alkalines, bleaches, solvents, flam- mable material, or industrial grade solutions can damage the pump. Many detergents may require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle.

nRemove the cap from the detergent container and pour detergent in the container. Replace cap on container.

nRotate the spray selector on the 5-in-1 Change Over

Nozzle to either the short range detergent [] or long range detergent [] setting.

nSpray the detergent on a dry surface using long, even, overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.

NOTE: To use a detergent bottle, open the detergent container cap. Next, remove the filter from the end of the injection hose then slide the hose out of the cap. Place the injection hose filter back on the hose and place the hose in the bottom of the bottle.

For long range detergent application:

With the nozzle installed on the spray wand and the engine shut off, rotate the spray selector to the long range detergent [] setting.

For short range detergent application:

With the nozzle installed on the spray wand and the engine shut off, rotate the spray selector to the short range deter- gent [] setting.

Before shutting off the engine:

nPlace the injection hose in a bucket of clean water.

nFlush for 1 - 2 minutes (spray clear water through the spray wand).

nShut off the engine.

NOTE: Shutting OFF ( O ) the engine WILL NOT relieve pres- sure in the system. Pull trigger to release water pressure.

RINSING WITH THE PRESSURE WASHER

nTurn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.

nEngage the lock out on the trigger handle by pushing up on the lock out until it clicks into the slot.

nRotate the spray selector on the 5-in-1 Change Over Nozzle to either the [40º], [25º], or [0º] setting depending on the job. Refer to the chart in Using the 5-in-1 Change Over Nozzle to determine which setting is correct for your application.

nWhen using these settings, test a small area first to avoid surface damage.

nStart at the top of the area to be rinsed and work down, overlapping the strokes.

MOVING THE PRESSURE WASHER

See Figure 20.

NOTE: Never lift or carry this product using the handle and never place the unit in any position other than upright on its wheels.

nTurn the pressure washer off and ensure the fuel valve is closed.

nPull the handle up until the handle release knob snaps into the locking position (if not already up and locked). Ensure the lock is secured in the frame hole before moving.

nTilt the machine toward you until it balances on the wheels then roll the machine to the desired position.

Page 12 — English

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PSI Pressure Washer Save this Manual for Future ReferenceSoap Soap Iii Paper clip pièces de papier, clips de papel Table of Contents IntroductionRead ALL Instructions Important Safety Instructions3 English Specific Safety Rules 4 EnglishSymbols 5 English6 English Features AssemblyConnecting High Pressure Hose to Trigger Handle Connecting the High Pressure Hose to the PumpPacking List Tools NeededConnecting the Garden Hose to the Pressure Washer OperationAttaching Injection Hose See Figures 9Applications Adding Lubricant to the EngineStarting and Stopping the Pressure Washer Oxygenated FuelsUsing the Spray Wand Trigger INSTALLING/REMOVING NozzlesUsing the 5-IN-1 Change Over Nozzle Using the High Pressure HoseWashing with Detergent Rinsing with the Pressure WasherMoving the Pressure Washer See Figures 18Maintenance Pump Lubrication Storing the Pressure WasherPreparing for USE After Storage 14 EnglishMaintenance Items Each use Weekly 25 hrs 50 hrs 200 hrs Periodic Maintenance Schedule15 English Problem Cause Solution Troubleshooting16 English Limited NON Engine Warranty Statement Warranty17 English Instructions Importantes Concernant LA Sécurité AVERTISSEMENT Lire Toutes LES Instructions  Faire preuve de prudence pour éviter de glisser ou tomberRègles DE Sécurité Particulières 4 FrançaisAvertissement Symboles5 Français 6 Français Caractéristiques AssemblageListe DE Contrôle Outils NécessairesRélever ET Abaisser LA Poignée Assemblage DE Poignée DE GâchetteInstallation DU Tuyau D’INJECTION UtilisationConnexion DU Tuyau D’ARROSAGE AU Nettoyeur Haute Pression AJOUT/VÉRIFICATION DE LubrifiantCarburants Oxygénés Appoint D’ESSENCEMise EN Marche / Arrêt DU Nettoyeur Haute Pression Voir les figures 13INSTALLATION/RETRAIT DES Buses Fonctionnement Poignée DE GâchetteUtilisation DE LA Buse À Permutation 5 EN Utilisation DU Tuyau Haute PressionDéplacement DU Nettoyeur Haute Pression Nettoyage Avec DU DétergentRinçage Avec LE Nettoyeur Haute Pression Voir les figures 18 etEntretien Entretien DE BuseEntretien Général Nettoyage DU Filtre À AIRRemise EN Service Après Remisage Changement Huile DE MoteurLubrification DU Pompe Remisage DU Nettoyeur Haute PressionTableau DE Calendrier D’ENTRETIEN Périodique 15 FrançaisDépannage Problème Cause Solution16 Français Énoncé DE LA Garantie Limitée Hors Moteur Garantie17 Français Guarde Estas Instrucciones Área DE Trabajo Instrucciones DE Seguridad ImportantesPágina 3 Español Reglas DE Seguridad Específicas Página 4 EspañolSímbolos PeligroAdvertencia PrecauciónPágina 6 Español Características ArmadoLista DE Empaquetado Herramientas NecesariasLevantar Y Bajar EL Mango Armado DE Mango DEL GatilloCómo Conectar LA Manguera DE Inyeccion FuncionamientoPágina 9 Español Usos Abastecimiento DE Lubricante DEL MotorCombustibles Oxigenados Abastecimiento DEL Tanque DE GasolinaUSO DEL Mango DEL Gatillo Instalar Y Desmontaje LAS BoquillasUSO DE LA Boquilla Intercambiable 5 EN USO DE LA Manguera DE Alta PresiónTraslado DE LA Lavadora DE Presión Lavado CON DetergentePágina 12 Español Mantenimiento Mantenimiento GeneralMantenimiento DE LAS Boquillas Limpieza DEL Filtro DE AireCambio DE Aceite DE Motor Lubricación DE LA BombaGuardado DE LA Lavadora DE Presión Página 14 EspañolPrograma DE Mantenimiento Página 15 EspañolProblema Causa Solución Solución DE ProblemasPágina 16 Español Garantía Página 17 EspañolOPERATOR’S Manual Manuel D’UTILISATION Manual DEL Operador

UT80432 specifications

The Homelite UT80432 is a powerful and versatile electric chainsaw designed for homeowners and DIY enthusiasts who require a reliable tool for cutting and trimming tasks around the yard. As a part of the Homelite lineup, this chainsaw combines innovative technologies with user-friendly features, making it an ideal choice for both novice and experienced users.

One of the most notable features of the UT80432 is its robust 8-amp motor. This powerful engine provides ample cutting strength, allowing users to tackle various tasks such as pruning branches, cutting firewood, or handling small to medium-sized trees. The chainsaw's design focuses on efficiency, enabling users to make swift and precise cuts with minimal effort.

The UT80432 is equipped with a 12-inch cutting bar and chain, which strikes an excellent balance between maneuverability and cutting capacity. This length is suitable for a variety of applications, ensuring that users can perform their tasks effectively without being overwhelmed by the size and weight of the tool. Its lightweight construction further enhances usability, making it easy to carry and operate for extended periods.

Safety is a paramount concern in any power tool, and the Homelite UT80432 doesn't fall short in this aspect. It features a chain brake that immediately halts the chain's operation in the event of kickback, providing an additional layer of protection for users. Additionally, the chainsaw includes a safety switch to prevent accidental starts, ensuring peace of mind during operation.

Another key characteristic of the UT80432 is its tool-free chain tensioning system. This feature simplifies the process of adjusting the chain tension, making it easier for users to maintain optimal performance without the need for specialized tools. The clear viewing window for the oil reservoir allows users to easily monitor oil levels, which helps prolong the life of the chain and bar.

The chainsaw is further designed with ergonomic considerations. Its cushioned handle ensures a comfortable grip, reducing user fatigue during prolonged use. The overall weight distribution of the unit contributes to better control and stability, which fosters greater precision during cutting tasks.

In summary, the Homelite UT80432 is an efficient and user-friendly electric chainsaw that stands out due to its powerful motor, lightweight design, safety features, and easy maintenance capabilities. It is a practical addition to any homeowner's toolkit, particularly for those looking to manage their outdoor spaces effectively and safely.
Top Page Image Contents