English
Fine Tuning the Polaris Cleaner
When operating correctly, the Polaris vacuums and sweeps all surfaces, moving randomly throughout the pool. The surface module floats on the water’s surface recirculating clean, filtered water. The sweep hose and filter bag move across the pool floor collecting dirt and debris.
Approximately every
Pressure Relief Valve
The pressure relief valve in the Quick Disconnect automatically releases water if the Polaris is receiving too much water pressure. It can also be used to regulate the movement of the cleaner.
If the Polaris changes directions too quickly, adjust the pressure relief valve to slow the cleaner.
Quick Disconnect
Preasure Relief Valve
Filter Screen
Routine Maintenance
Cleaning the Filter Bag
Depress the buttons on the jet sweep assembly to release the bag. Turn the filter bag
Open frame completely and reattach bag.
Cleaning the Filter Screen
Jet Sweep Assembly
Frame
Filter Bag
Button
The filter screen inside the Quick Disconnect captures debris missed by the pool filtration system. To clean, pull it out, rinse it and press it back into place.
Backwashing the Pool Filter
Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool filter. After cleaning or backwashing, let the filtration system run for at least five minutes to flush out the return lines before
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water (freeze damage is not covered under the warranty). Remove the sweep jet assembly from the sweep hose and store it flat. Hang or lay the hoses straight. Remove all fittings from the return lines including the UWF. In some cases, it may be necessary to use the UWF Removal Tool (part
www.polarispool.com