2 | Adjust Sweep Hose to Fit Pool Depth |
1. Measure the deepest part of the pool. | |
Add two feet to this measurement to | |
determine the correct length for the |
sweep hose.
Collapse Here
English
2.If the sweep hose is longer than the measured amount, cut off the excess hose.
3.Remove the hose connector from the excess hose piece just cut.
4.Use fingers to collapse sweep hose. Push hose into connector until the first groove is inside.
5.Slide fingers inside hose, through connector, and pop hose back to original shape.
Hose
Connector
Insert
to Here
Adjust Float Hose to Fit Pool Length
3 With float hose attached to the pool wall at the return line, extend the hose to the farthest
point of the pool. The end of the hose should be 4 feet shorter than this point.
Hose too long? Cut the excess float hose. Remove the hose connector from the excess hose piece and attach it to the new end of the float hose as instructed above.
Hose too short? For Polaris 165/Super Turtle only, add the float hose extension between the existing float hose section and the surface module. Remeasure and adjust as necessary.
4 feet
Return line
1.Open the frame of filter bag completely and attach it to jet sweep assembly. Attach assembly to sweep hose.
2.Attach float hose and sweep hose to the surface module.
3.Put the Polaris in the pool and turn on the pool filtration pump.
4.Extend the float hose to the farthest point in the pool. When the pool pump is running, the surface module should be approximately one foot from the pool wall.
www.polarispool.com