Sanyo SRT-2400DC instruction manual Back Panel, Wvut Q O N

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001

LOCATIONS OF CONTROLS AND INDICATORS

Back Panel

1

ALARM OUT/	ALARM IN/		SERIES OUT/	SERIES	SW	EJECT
CLOCK OUT	CLOCK IN	COM	NON REC OUT	IN	OUT	OUT	IN
WARNING	TAPE
OUT	END OUT	COM			COM

DC12V IN	AUDIO VIDEO
PUSH	IN
OPEN	IN
REMOTE MIC IN	OUT
	OUT

	P
WVUT	S R Q O N

23456789

ALARM OUT/ ALARM IN/			SERIES OUT/ SERIES	SW	EJECT
CLOCK OUT	CLOCK IN	COM	NON REC OUT IN	OUT	OUT	IN
WARNING	TAPE	COM		COM
OUT	END OUT

M L K J I H G F

NOTE:

This terminal board may be damaged by

0.49N·m (5kg·cm) or

more torque and using φ6mm-tip or more size screwdrivers.

1Battery compartment

2ALARM OUT/CLOCK OUT (alarm output/external clock set trigger output) terminal

3ALARM IN/CLOCK IN (alarm input/external clock set trigger input) terminal

4COM (common) terminal

5SERIES OUT/NON REC OUT (series recording trigger output/non recording output) terminal

6SERIES IN (series recording trigger input) terminal

7SW OUT (switch output) terminal

8EJECT OUT (eject trigger output) terminal

9EJECT IN (eject trigger input) terminal

FDo not use

GDo not use

HCOM (common) terminal

IDo not use

JDo not use

KCOM (common) terminal

LTAPE END OUT (tape end output) terminal

MWARNING OUT (warning output) terminal

NVIDEO IN (video input) jack

OVIDEO OUT (video output) jack

PAUDIO IN (audio input) jack

QAUDIO OUT (audio output) jack

RMIC IN (microphone input) jack

SREMOTE (remote control input) jack

TDC 12 V IN “+” input terminal

UDo not use

VDC 12 V IN “–” input terminal

WFuse cover

NOTE:

•A fuse has always to be replaced by a fuse with the same ratings (125 V, 3.15 A).

6 English