Sanyo SRT-2400DC instruction manual Connections, About the memory reset

NU4QG/NA3 (SRT-2400DC GB) Mon. Sept., 17/2001

CONNECTIONS

Connect the video camera and monitor TV as shown in the figure below.

NOTE: Before making the connections, make sure all the devices are disconnected from the DC power supply.

Monitor TV (sold separately)

Video camera (sold separately)

From an external				To
				VIDEO IN
audio source
				jack
ALARM OUT/ ALARM IN/	SERIES OUT/	SERIES	SW	EJECT
CLOCK OUT CLOCK IN COM	NON REC OUT	IN	OUT	OUT IN
WARNING TAPE
OUT END OUT COM			COM
DC12V IN		AUDIO		VIDEO
PUSH				IN
OPEN		IN
REMOTE MIC IN OUT				OUT
				To
To remote				VIDEO OUT
				jack
control
(sold separately)				Coaxial cable
				(sold separately)

To DC power supply

About the memory reset

If the VCR location is changed or to cancel previous settings, please reset the memory as described below.

The time and date will be reset, and the security lock will be cancelled.

To reset the memory, press the ALL RESET button.

NOTES:

•For more details, please refer to the manuals accompanying all other devices. If the connections are not made properly, it may cause a fire or damage the equipment.

•You can use a VA-RMN01 Remote Control Unit (sold separately) to control remotely the VCR.

•If there is no video signal when the power is turned on, “NO VIDEO” will be displayed on-screen.

•Use a DC power cord rated A.W.G 18 (1.25 mm2) or more.

•The table below indicates the DC power source output and DC power maximum cord lengths.

DC power source output			DC power maximum cord
			lengths
16 V	3	A	6 m
14 V	3.5 A		6 m
12 V	4.5 A		6 m
10 V	7	A	6 m
10 V	5	A	2 m

8 English