Unsuccessful calibration
Preparing documents for scanning
If calibration is not successful, a message appears in the status display.
You may need to:
∙Verify you are using a clean, blank sheet of paper as a calibration target.
∙Verify there is not a document already in the document path. (Refer to the section entitled, “Clearing the document path” in Chapter 7.)
∙Clean the imaging guides. (Refer to the section entitled “Cleaning the imaging guides” in Chapter 5.)
∙Calibrate the scanner again. If calibration fails again, change the lamps. (Refer to the section entitled, “Replacing the exposure lamps” in Chapter 5.)
If you have done all of the above and calibration still fails, contact your service representative.
Before you begin processing documents, make certain that the documents may be fed through the scanner easily.
∙Remove any staples, rubber bands, loose mending tape, or paper clips from the documents to be processed.
∙Straighten wrinkled edges and tape any torn documents.
∙Trim ragged edges.
When using the
|