Kodak A-61092 manual Feeding documents using the automatic feeder

Feeding documents using the automatic feeder

Following are document feeding instructions using the automatic feeder. After the scanner has been prepared for operation, the desired mode and any temporary operating values have been defined, you are ready to feed documents into the transport.

1.Verify that the power is on and that any adjustments have been made (feeder side guides, exit hopper side guides, etc.).

2.Select a stack of documents that is no more than 1.5 in. (38 mm) thick. Hold the stack with the front sides facing up and the top of the documents facing toward the scanner. Tap the top edge of the stack against a flat surface so the documents are in an even bundle.

3.Fan the stack of documents so the leading edge of the top document sticks out the farthest.

4.Lift the feeder module up and slide the leading edge of the document underneath the feeder module. To help prevent multiple feeds, place the stack of documents under the feeder module and pull the stack back slightly (about ¼-inch) from the separator roller.

5.Press Run.

NOTE: Be sure the documents are center-fed so each document covers the 3 ½-inch required width.

6.As you scan documents, set the image level, as required, and periodically remove documents from the exit hopper.

7.Repeat Steps 2 through 4 until all of the application documents have been fed into the transport.

8.Press Stop after all documents have been deposited in the exit hopper.

A-61092 September 1999 3-5