IBM N2800e manual Replacing a CompactFlash card, Installing an optional PCI card

Replacing a CompactFlash card

Read “Caution notices” on page vi, and “Removing the logic unit to install parts” on page 45 before continuing.

1.Uninstall the N2800e thin client CompactFlash card by

pulling it out of the connector .

2.Match the grooves on the sides of the CompactFlash

card that you are installing (		) to the inside of the
connector	.
3. Install the CompactFlash card		into the connector
.

Note: Do not force the card into the connector, as it will damage both the thin client, and the CompactFlash card.

4.See “Reassembling the thin client” on page 45.

Installing an optional PCI card

Complete the procedure, “Removing the logic unit to install parts” on page 45 before performing the following Peripheral Component Interconnect (PCI) procedure.

1.	Loosen the thumb screw	to slide the plate	up.
2.	Remove the PCI slot covers	.

3.From inside the logic unit, install the PCI card down

into both the slot, and the PCI socket .

Note: Inserting the first PCI card into the socket closest to the logic board makes installing a second PCI card easier.

4.Install PCI slot covers over any empty slots.

5.	Slide the plate	down until the tabs		secure the
	PCI slot covers	firmly into place.
6.	Tighten the thumb screw		,
7.	See “Reassembling the thin client” on page 45.

46