Installing the power supply:
1.Carefully install the power supply into the logic unit so that the power supply fan assembly faces the front of the logic unit.
2.Slide the power supply toward the back of the logic unit until it stops.
3.Make sure that the power supply is seated correctly, and firmly into the logic unit.
4.Secure the power supply with the three Phillips
head screws | removed during the power supply | |
removal procedure. |
| |
5. Slide the support plate | into place between the | |
riser card and power supply.
6.Secure the support plate with the two Phillips head
screws | removed during the power supply | |
removal procedure. |
| |
7. Install the power connector | into its socket on | |
the logic board. |
| |
8. See “Reassembling the thin client” on page 45.
Appendix B. Hardware maintenance procedures 49