IBM CF Series manual Merge and Splice Adjustment Menu

5.1.8 MERGE AND SPLICE ADJUSTMENT (8)

This feature lets you precisely adjust the effective camera position to eliminate discontinuities across camera boundaries. Merging is adjustment along the scan line. Splicing is adjustment perpendicular to the scan line.

______________________________________________________________________

NOTE: Focus, magnification, merge, and splice functions are intertwined. If you adjust one, you must test and, if necessary, adjust the other functions. This must be done in the following order:

1.Focus

2.Magnification

3.Merge

4.Splice

______________________________________________________________________

When you press <8> to select this option, the prompt, “ Use Electronic Splice ? [N]”, appears. If you reply with <N>, you will be able to adjust only the merge. If you reply with <Y> and electronic splice is enabled in Global Parameters, both merge and splice can be adjusted. (To enable electronic splice, set global parameter 2 to “ON.”)

The prompt, “Use Bar Pattern? [N],” the appears. For the purpose of this test, reply to the prompt with <N> or just a <CR> .

	----- Merge		and Splice Adjustment -----
		Boundary Indicator
	0	1	2	3	4	5	6	7
Threshold		35	Range 00-63 Decimal
	Merge	2F	Range 00-FF Hex
	Splice	0	Range -5 to +5
	Motor	Full Forward
	Status	Paused
Delay	Counts	00	00	00	00	00	00	00 00
------------------------- MENU-------------------------
left arrow : Boundary Left					right arrow : Boundary Right
up arrow : Threshold Up					down arrow : Threshold Down
< or , : Increase Merge						> or	. : Decrease Merge
( or 9 : Increase Splice						) or	0 : Decrease Splice
space bar : Pause / Unpause
S : Select Scanning Speed							R : Reverse Motor
F : Fast Paper			Movement				X : Exit

Figure 5-17 Merge and Splice Adjustment Menu