2.2Setup
2.2.1Document Catch Installation
The document catch has three keyhole type slots. Insert the studs on the rear of the scanner (about an inch above the fan) into the three keyhole slots and push down firmly to seat them in the slots.
2.2.2 Environmental Concerns
The following conditions must be met to ensure acceptable working conditions for the scanner:
2.2.2.1 Site
The site has to be relatively dust free. The environment should also generate a low degree of static electricity.
2.2.2.2 Airflow
There must be at least one foot of clearance in the rear of the scanner to allow for proper airflow. Do not place the scanner near a heating panel or vent.
2.2.2.3 Ambient Light
In order to keep the light uniform on the document being scanned, no direct sunlight or bright lights should fall on the unit.
2.2.2.4 Vibration
Excessive vibrations in the room should be avoided in order for the delicate settings of the cameras to remain unchanged.
2.2.2.5 Temperature
The ambient temperature in the room should average between 18 and 30 degrees C
2.2.2.6 Humidity
The point of condensation should not be reached in the room.