IBM CF Series manual

2.Locate the CALS Board which is in the left-most slot of the card cage.

3.Locate the memory write protect switch, SW1, on the CALS Board.

4.Turn the toggle switch down (memory write enable position). The toggle switch is factory set to the down position.

5.Issue the SAVE command by either method described above.

6.If desired, turn the toggle switch up (memory write protect position)

7.Close the door and cover.

______________________________________________________________________

CAUTION: The save command will save every change made since the last power-up or system reset. If you are changing specific parameters, perform “System Init” before you change the parameters. This will insure that you do not alter parameters you had no intention of changing.

______________________________________________________________________